Support
Recumbent Spa System
RECUMBENT SPA SYSTEM
ARCHITECTURAL SPECIFICATIONS & ROUGH-IN INFORMATION
BATH TUB
Dimensions
Width
35 ½"
Length
84"
Side Deck Height
34 ½"
Control Deck Height
38 ¾"
Specifications
Back Flow Prevention:
Air gap for tub fill spout. Note: The factory provided backflow prevention is the most widely accepted. Local codes may require changes, which is the responsibility of the local plumbing contractor.
BathAire(SM) Outlets:
4 with 12 ports each for a total of 48 warm air massage outlets.
Electrical:
Provide separate 115V-AC, 60 Hz, 20 Amp. circuit and receptacle with in-line ground fault interrupter (not supplied) in accessible location.
Installation Time:
1 hour.
Inspection and Adjustments:
½ hour.
Motor Specs:
BathAire(SM) Motor: 115 V, 7 Amp, 1.3 H.P. Adjustable speed for maximum comfort and control.
Room Size:
7' wide x 8'10" long minimum recommended. Can fit in smaller room; call MasterCare with dimensions.
Switches:
Membrane
Thermometer:
Analog or Digital temperature measurements.
Tub Fill/Shower:
30 GPM thermoscopic mixing valve with separate fill and shower flow control valve.
Tub Shell:
Sanitary gel-coated FRP (Fiberglass Reinforced Polymer).
Tub Water Use:
65 gallons
Waste:
2" PVC schedule 40 pipe.
Water Connection:
¾” SS braided flex hose with female pipe thread connections.
Water Supply:
¾” Copper hot and cold. Minimum of 30 PSI for hot and cold required. Maximum temperature of hot water supply 115°F or code, whichever is less.
Weight
400 lbs
RECUMBENT STRETCHER LIFT AND SCALE
Dimensions
Stretcher Platform with Head Rest
70” Long, 22” Wide
Overall Width of Lift-Without Scale
36” Door opening clearance
Overall Width of Lift-With Scale
37 ¾” Door opening clearance
Lift Base
44 1/2” Long, 28” Wide
Travel (Stroke) Range
19 ½” Up and Down
Stretcher Platform
40” Up Position
Bottom Height
21” Down Position
Top of Column Height
50” Down Position
70” Up Position
Stretcher Lift Specifications
Battery:
24 V output at 2.0 Ah, high capacity with over 60 cycles when fully charged.
Capacity:
400 lbs
Caster:
Four inch rear swivel casters with brake, three inch dual wheel swivel casters.
Comfort Pads:
Vinyl
Construction
100% powder coated aluminum with stainless steel hardware.
Power:
24 V DC actuator system for quiet, efficient operation.
Weight:
175 lbs. Shipping
Scale Specifications
Accuracy:
Within 0.1% of capacity
Capacity:
The scale uses 2 - 200 kg., single point, aluminum load cells with potted gauges for moisture protection. The load cells have matched output so that load cell exchange does not then necessitate calibration.
Display:
LCD with .6" high characters
Electronics:
Utilizes a microprocessor controlled digital electronics for reliable operation.
Mechanical:
Electronics enclosure is stainless steel with plastic overlay. The load cell
supports are heavy gauge stainless steel. All fasteners are stainless steel.
Mode:
Pounds (lb) and Kilograms (kg)
Power:
Four AA Alkaline Batteries.
Repeatability:
Within one displayed division.
Resolution:
The present resolution is .5 lb. If finer resolution is needed, it is factory programmable.